The granule pipe chain conveyor developed and produced by Anqiu Boyang Machinery Co., Ltd. implements non-standard customized production to ensure that each piece of equipment is brand new before leaving the factory. After the customer installs the equipment under the guidance of the professional staff of our factory, the particle tube chain conveyor will be put into use. Because each new mechanical device requires a long period of running-in adjustment at the beginning of the operation, the performance of the device can be optimized. Therefore, when customers purchase our company's particle chain conveyor, you can adjust the equipment according to the following steps, so that the performance of the particle chain conveyor can be adjusted to the best speed. The particle tube chain conveyor operation adjustment takes about one month, during which we divide the weekly into an adjustment phase. In the first week, the inner chain is inspected every day. If the chain is found to be slack, it needs to be tightened immediately. In the second week, it is required to check the components of the pipe chain every day. If there are any push plates, chain plates and cotter pins that are found to be worn, you need to find the cause of the fault first. (If there are large blocks stuck in the middle of the two chain plates, round After the pin is deformed, etc., it is replaced after it is found; the third and fourth weeks are viewed twice a week, pay attention to the wear condition. If there is serious damage, first find the cause and then replace it. If the chain is loose, it should be inflated in time. tight.
After a month of inspection and adjustment, the performance of the particle tube chain conveyor equipment is already at its best. However, it is still required to inspect the particle pipe chain conveyor once a week to ensure that the chain is tight and the machine runs smoothly during the operation. The operator should pay attention to check the various parts of the conveyor, especially the chain and drive device in the pipe should be kept intact. Once the defective detachment mechanism is found, it should be repaired or replaced in time (the adjustment of the telescopic device will loosen the chain before it can be disassembled. After replacement, disassembly and replacement, adjust the telescopic device to expand the chain, which will ensure the best performance of the equipment and extend the service life of the equipment.
